• Can send ON, OFF, DIM, BRIGHT, All Lights On, All Units Off or All Lights Off commands (depending on the programming).
• Adjustable for fixed mode or toggle mode sending of ON/OFF commands.
• The dimmer interface is adjustable for use with Momentary switches with one or two, normally open contacts (optionally with zero position, multi-switch).
• Adjustable for automatic request for status information (two-way communication, status request).
• Adjustable for receipt of group commands for a status update in toggle mode.

Suitable for the connection of:

• Four 1-pole (rocker) switches.
• Four 1-pole, normally open contact, Momentary switches.
• Two Momentary switches with two normally open contacts (optionally with zero position, multi-switch).
• One Momentary switch with four normally open contacts (optionally with zero position, multi-switch).
• Four random potential-free contacts with a common contact (P contact).

• Rated voltage : 230 VAC +/- 10% , 50 Hz
• Current consumption : < 30 mA capacitive
• Signal transmission : > 5 Vpp in 5 Ohm at 120 kHz
• Transmission synchronization : 1 pulse burst at 0°/180°
• Signal sensitivity : 25 mVpp...6 Vpp at 120 kHz ± 4 kHz
• Signal/noise ratio : 1,35 : 1
• X10 Key codes transmitting : ON, OFF, BRIGHT, DIM, All Lights ON, All Lights OFF, All Units OFF, extended X10 Key codes receiving ON, OFF, BRIGHT, DIM, extended, Status Request
• Connection range : Up to 2.5 mm2, tightening torque 0.5 Nm
• Ambient temperature : 0 °C to 35 °C
• Relative humidity : 30 tot 90% (non condensing)
• Dimensions : 46x46x16mm
• Minimal back box depth : 40mm, advice 50mm
• Download manual