• Makes the Marmitek X10 system operable remotely via RF
• Easy to install
• Designed as a wall- or ceiling mountable unit or stand-alone use
• A maximum of 256 addresses can be controlled with one RF interface
• RF-secured, only signals from registered remote control units are accepted
• A maximum of eight remote control units can be registered in the RF-secured mode
• Maximum communication distance: 100 m (open field)
• Dimensions: 120 x 80 x 30 mm
• Colour: RAL 9001

The RF interface is a receiver that converts RF signals originating from the Marmitek X-10 remote control units into Marmitek X-10 commands and subsequently sends them over the lighting circuit.

The RFIX35 makes wireless and remote operation of the Marmitek X10 system possible. The RF interface can be mounted on a junction box or against a distribution box, but can also be mounted against the rear wall of the meter abinet, if required. The RFIX35 can also be plugged into a wall socket outled.

• Mains voltage : 230 Vac, 50 Hz
• Max. power consumption : < 2 W
• Ambient temperature : 0 to 40 °C
• Frequency : 433,92 MHz; X-10 RF (NEC) compatible protocol
• Max communication distance : 100 m (open field)
• Protection class : Class II, Double insulated
• Type of protection:
  IP 40 with wall or ceiling installation
  IP 20 with installation on the wall
• Standards : IEC 60950

Housing
• Dimension (H x W x D): 120 x 80 x 30 mm
• Color : RAL9001

Power cable
• Dimension : Length 1.5 m
• Color : White
• Download manual