• 5+1 FREE
• Extremely small size (46x46mm and only 16 mm thick)
• Two-way X-10 communication
• Transmits ON when contacts are opened, transmits OFF when contacts are closed
• HouseCode, UnitCode and settings can be simply programmed with every X-10 compatible controller (e.g. Marmitek 8in1 in combination with TM13 transceiver). Except with the CM11 computer interface
• Improved S/N ratio for reliable X-10 communication
• Power/Status/Configuration LED

• Remote ON/OFF control of electrical loads
• Combine your Marmitek X-10 system with sensors, alarm outputs, etc. by hooking up to NC (normally closed, open=ON, close=OFF) output contacts
• Provides power line carrier control to existing light switches
• Transforms conventional switches into an X-10 transmitter
• Full control of all your X-10 modules by conventional switches
• Choose your own brand, design and colour for switches and wall sockets
• Place X-10 modules out of sight
• Ideal for installation into limited areas
• Use a conventional switch on a fixed location to execute Macro’s

COMPATIBLE WITH:

• ACT A-10
• Aritech CS 575/275/175 series X-10 power line carrier control
• Busch Jaeger Timac
• Busch Jaeger Netzbus
• Honeywell TotalHome
• Marmitek X-10
• Visonic PowerMax X-10 power line carrier control
• X-10 (220V)
• X-10 PowerHouse (220V)

TMA4 transmits signals for use one phase only.
Use the CAT4000 repeater (Art.No. IH5615) to enable you to receive TMA4 commands on other phases.

Power
Supply Voltage : 230VAC, +10%/-15%
Frequency : 50Hz
Supply current : Less than 50 mA
Signal
Signal input X-10 PowerLine Carrier, sensitive to 50mV
Signal output X-10 PowerLine Carrier, 5Vpp @ 5 Ohms

Three phase use
The TMA4 transmits signals for use one phase only.
Use the CAT4000 repeater (Art.No. IH5615) to enable you to receive TMA4 commands on other phases.
The TMA4 receives commands from standard Marmitek X10 transmitters on different phases.
Four wall switch inputs (dry contact).
Five 120mm, 0,33mm²
Flying leads:
Switch input 1: Brown
Switch input 2: Red
Switch input 3: Orange
Switch input 4: Yellow
Switch common: Blue
Programming
Can be programmed by every Marmitek X-10 compatible controller. Can also be programmed by special Marmitek PRU256 programmer/X10 logger (Art.No. IH5600).
Mechanical requirements
Power
Screw terminals (2x) L – Will handle up to 2,5mm² solid copper wire
N – Will handle up to 2,5mm² solid copper wire
Enclosure
Dimensions : 46 x 46 x 16 mm
Weight : 26 grams
Mounting Sized for mounting of 75 x 75 x 50mm European round electrical junction box, or other limited areas
Environmental parameters
Operating Temperature Range : 0 to +40° C
Storage Temperature Range : -20 to +70° C
Humidity Range : 10 to 95% non condensing
Approvals
NEN-EN-IEC 60669-2-1, NEN-EN-IEC 60669-2-2, CE
Specifications may change without notice to improve product performance

Download brochure - Download manual

FOR PROFESSIONAL USE ONLY! FOR INSTALLATION CONSULT AN ELECTRICIAN

The TMA4 micromodule can NOT be programmed with the CM11 Computer interface.