• Transmission of ON/OFF/BRIGHT/DIM commands.
• Responds to ON, OFF, DIM, BRIGHT and extended dim level commands.
• One user-definable address (free programmable address) A1-P16.
• Suitable for operation with retroactive switches with 1 or 2 normally open contacts.
• Can be used as an actuator for placing behind wall sockets
  (insulating connecting wires).

The DAIX12 is both a dimming actuator and an interface equipped with a 230 V input. This module must be fitted in junction or distribution boxes and can be used in combination with: Wall sockets, Retractive switches with one or two normally open contacts. The DAIX12 can be used for easy automation of lighting circuits so that they can be switched or dimmed remotely or manually.

Connection applications
Suitable for the connection of:

• Retractive switches:
  
  • One retractive switch with two normally open contacts (two-level operation).
  • One retractive switch with one normally open contact (single-level operation).
• Wall sockets:
  
  • One wall socket

• Rated voltage 230 Vac, 50 Hz
• Output :
  • 250 W (*) bulbs
  • 200 VA (*) Halogen lighting with wound transformer
  • 250 VA (*) Halogen lighting with leading edge electronic transformer (**)
• Cartridge fuse : Radial lead micro fuse, 1.6 AT,
  according to IEC 60127-3, standard sheet 4
• Current consumption : < 30 mA capacitive
• Signal transmission : > 5 Vpp in 5 Ohm at 120 kHz in accordance with
  EN 50065-1, EN 50065-2-1, EN 50065-4-1
• Transmission synchronization : 1 pulse burst at 0°/180°
• Signal sensitivity : 25 mVpp…6 Vpp at 120 kHz ± 4 kHz
• Signal/noise ratio:  1,35 : 1
• Connection range : Up to 2.5 mm2, tightening torque 0.5 Nm
• Minimum ambient temperature 0 °C
• Maximum ambient temperature 40 °C (*) (***)
• Atmospheric pressure 86 pkA - 106 pkA
• Relative humidity (non condensing) 30 tot 90%
• Standards NEN-EN-IEC 60669-2-1, NEN-EN-IEC 60669-2-2
• Marking : CE
• Download manual