Reference: 08070
34,95 Euro
£ 32,66
Quantity
Add to cart
|
LMM31 - Lamp/Dimmer Module
Commercial Information
NEW! LMM31 - Lamp-/Dimmer Module, MicroModule, ON/OFF/DIM, 1 load |
|
Remote Control ON, Off and Dim
- Suitable for 230V and low-voltage lighting wit a transformer, including halogen lighting.
- Remote control via the mains using Marmitek X10 commands and with one or more momentary switches
- Switches and dims lighting up to 300W.
- Can be used in combination with 'designer' switching material.
- Soft start and smooth dimming features, remembers the last dim setting.
- Makes your X10 system invisible.
- Can be regulated from 0% to the desired dim setting.
- The modules is not suitable for dimming and controlling low-energy light bulbs and tube lighting. An appliance modules should be used for these devices.
- Phase and Neutral have to be available before the module can be installed.
- Small enough (34,25X47X21mm) to fit into a wall box behind a standard wall switch.
- Supply voltage: 230VAC +10% -10% 50Hz
- Power consumption: < 1W
- Making capacity: 25 - 300W for incandescent light bulbs and halogen lighting
- Control Load QTY: One
- Dimmable: Yes
- Signal sensitivity: better than 25 mVpp at 120 kHz
- X10 Key codes to respond: All units off, All units on,On, Off, DIM, BRIGHT, Extended Dim
- Input switch: 1-way standard rocker switch, 1-way momentary switch (normally open contact)
- Use in 3 phase installation: Wire for a standard rocker switch or momentary switch and connecting clamps for phase, neutral and switched phase.
- Control lines: Not more than 1 meter between the micro module and the switch
|