Reference: IH07600
89,95 Euro
£ 84,07
Quantity
 Add to cart
|
SAIX12 Switch Actuator / Interface
Commercial Information
 - Switch actuator for installation behind switches, retractive switches, movement sensors, wall sockets of in distribution boxes. Suitable for remote and/or on-site operation of lighting and equipment.
|
|
- Option of sending alternating ON/OFF commands (toggle).
- Responds to ON and OFF commands.
- Sparkfree activation and deactivation of loads.
- Two independently programmable 230 V inputs (addresses A1-P16)
- One input for local relay operation and the transmission
of the corresponding ON/OFF command.
- One 230 V input for relay-independent transmission of ON/OFF commands, for example for use as a 230 V interface behind movement sensors.
- Status retention in the event of the loss and recovery of main voltage (bi-stable relay).
- Can be used as actuator for placing behind wall sockets (insulating input wires).
Suitable for the connection of:
- Two single-pole (rocker) switches.
- Two retractive switches with one normally open contact.
- One series switch.
- One retractive switch with two normally open contacts.
- Two non-specific 230 V switch signals (e.g. movement sensors).
- One wall socket (WS).
- Rated voltage : 230 Vac, 50 Hz
- Rated current : 16 A (*)
- Current consumption : < 30 mA capacitive
- Signal transmission : > 5 Vpp in 5 Ω at 120 kHz
in accordance with EN 50065-1, EN 50065-2-1, EN 50065-4-1
- Transmission synchronization : 1 pulse burst at 0°/180°
- Signal sensitivity : 25 mVpp…6 Vpp at 120 kHz ± 4 kHz
- Signal/noise ratio : 1.35 : 1
- Connection range : Up to 2.5 mm2, tightening torque 0.5 Nm
- Minimum ambient temperature : 0 °C
- Maximum ambient temperature : 40 °C (**) (***)
- Atmospheric pressure : 86 pkA - 106 pkA
- Relative humidity (non condensing) : 30 tot 90%
- Standards : NEN-EN-IEC 60669-2-1, NEN-EN-IEC 60669-2-2
- Marking : CE
- Download manual
(*) The maximum load of switch actuators may not always be used as this depends
on various factors. Before using these modules, consult the manual on power
reduction for XanuraHome switch actuators (MBO 6012355G01 001). This manual
is supplied with the switch actuators.
(**) Xanura modules are suitable for use in homes where the ambient temperature in
the living area, under normal circumstances, is not higher than 35°C or may
(exceptionally) reach a maximum of 40°C.
(***) The maximum load on dimming and switch actuators is partly dependent on the
ambient temperature. Before using these modules, consult the manuals on power
reduction for dimming and switch actuators. These are supplied with the
dimming and switch actuators
|