• Watch and operate your HD Content elsewhere on your TV
• Watch films, look at photographs and listen to music from, for example, your Media Centre PC, Blu-Ray player, game console, set top box or hard-disk recorder on a different TV/projection screen in perfect HD quality.
• Operate your connected A/V equipment remotely via the infrared return signal.
• Wired signal transmission up to 100 metres!
• Optimum price/quality ratio as a result of using CAT5e/CAT6 cabling.
• Retention of Full HD 1080p image and sound quality for up to 60 metres.
• Free from interruption due to solid metal, interference free housing.
• Very simple to install or add into an unused CAT5 network.

Watch films, look at photographs from, for example, your Media Centre PC, Blu-Ray player, game console, set top box or hard-disk recorder on a different TV/projection screen in perfect HD quality.

CAT5e/CAT6 Cable requirements

• UTP-, FTP- or STP-cable
• 24AWG or lower
• Solid twisted pair
• 100 ohm at 1MHz
• RJ-45 jack according to EIA/TIA T568B standard

Instead of CAT5 cable, CAT6 cable may also be applied (this offers better quality). Use a "solid twisted pair "CAT-5e" or "CAT-6" cable in order to optimise transfer quality.

Resolution

• Supported HDTV Resolutions : 480p, 576i, 576p, 720p, 1080i, 1080p
• Single link Bit Rate (max): 1.65 Gbps
• Supported Standards HDMI : DVI, HDCP

Transmitter

• HDMI input (19-pin female) : 1 HDMI
• Video signal input : 0.5 - 1.0V p-p
• DDC signal input : 5V p-p

Receiver

• HDMI output (19-pin female) : 1 HDMI
• Video output HDMI : V1.2a
• CAT5e/6 cable length (max.) : 100m for 480p and 60m for 1080p

Transmitter/Receiver

• Dimensions (H x B x D) : 45mm x 25mm x 81mm
• Weight : 246g

IR Receiver : (MegaView61)

• Frequency range : < 40 KHz
• IR reception range: ± 6 meters
• Connection: 3.5 mm jack plug
• Cable length: 35cm

IR extender cable (MegaView61)

• Connection: 3.5 mm jack plug
• IR LEDs: 2x IR LED
• Cable length: 3 meters

Environment

• Ambient temperature : +0 to +70° C
• Ambient humidity : 10% to 85%

Power

• Input : 100-240VAC @50-60Hz
• Output : 5VDC 2A

 Download manual  - Download Brochure

Supported IR Frequency  : < 40 KHz. For remote controls that use a different infrared frequency (i.e. between 40 kHz and 60 kHz) you'll have to buy a separate 56 kHz IR Receiver (ref. IH92220 / 09883).

The MegaView 61 must be installed in an unused CAT5 or CAT6 network!

There must be a direct connection between the MegaView61 Transmitter and MegaView61 Receiver with two CAT5e/6 Ethernet cables.
The RJ45 plug on these cables must be connected according to EIA/TIA T568B standard, see manual page 39.  Make sure that the CAT5e/6 cable and the transmitter and receiver connections (CAT5e-1 and CAT5e-2) correspond to one another.

Do NOT loop in any other appliances such as e.g. a router.